Combining the rejuvenating properties of ground-breaking Multi-RF Technology, innovative Dynamic Muscle Activation and a Thermal Mapping Algorithm, the TriPollar STOP Vx GOLD is designed to support and enhance the natural beauty of your skin.

The three technologies combine to support collagen and elastin production, promoting a firmed, tightened and smoothed complexion. Luxurious 24-carat gold acts as the ultimate conductor, optimising the device’s technological efficacy. Helping to define the jawline, plump and tighten the skin and reduce the appearance of lines, this innovative device offers both immediate and long-term results in the comfort of your own home.

Features:

Multi Radio Frequency Technology: Uses interchanging Radio Frequency waves to evenly distribute heat throughout the dermis, creating a smoothing effect to reduce the appearance of fine lines and wrinkles.

Thermal Mapping Algorithm: Ensures the most personalised treatment, providing the most accurate temperature for the best results.

DMA: Targets the facial muscles to improve tone and create a V-shaped contour effect. An electrical current targets the different layers of the muscles, supporting density and volume both immediately and long-term.

• Cleanse and dry the face/neck area

• Apply a very thin layer of the TriPollar Gold Preparation Gel over the entire treatment area (face

and/or neck). This gel must be used during the entire treatment process.

• Turn the device ON by pressing the Power button. Make sure that the green indicator light

turns ON.

• Select the power setting (Low/High) that is most comfortable.

• Divide the face in 3 treatment areas (Right Cheek, Left Cheek, Forehead)

• Place the device on the skin, make sure to apply a slight pressure in order to assure full

contact between the electrodes and the skin.

• Move the device in a very slow circular motion on a small part of your treatment area,

slowly heating your skin to the optimal temperature.

• Once the orange indicator light illuminates followed by a ‘beep’ sound, you have reached

the optimal temperature. Continue the same slow circular motion for a few seconds, then

gradually enlarge the movements in the treatment area.

• Continue working on the entire treatment area in slow circular motion for 4-5 minutes, and

proceed to the next treatment area, repeating the above steps. Treatment can be augmented by

“lifting” movements from the jaw line upwards toward your cheeks.

• Switch to RF + DMA mode (only use it on the jaw line area). It's recommended to start at

the Low power level.

• Start moving the device using a very slow linear motions along the jaw line.

• To ensure optimal results, use the device for 5 minutes on each side. After the entire

treatment area has been treated, the treatment session is complete.

• Press the Power button for two seconds to turn the device OFF.

• Gently remove the TriPollar Preparation Gel for skin and wash face.

• Clean the electrodes of the device with a damp cloth or paper towel and cover the device tip

with its protective cover.